Impressive Info About How To Cure Animal Pelts

Use approximately half of the fat liquor oil.

How to cure animal pelts. Lay the pelt on a flat surface and use your fingers to work the brain solution over the skin until thoroughly covered. Cased pelts are removed by cutting the skin up. Don’t get your wet tanning solution on the fur.

Apply fat liquor oil to each pelt, using a paintbrush to spread it evenly. Cured pelt has a volume of 0.17 and a weight of 0.25. In the big bucket mix salt, alum and water in a ratio of roughly 1 gallon water, 1 kilo salt and 100g alum until you have enough to just submerge the skin.

Sprinkle with cornstarch to remove perspiration salt and odor, and brush off the cornstarch. You can tan, treat or preserve the pelt of a furbearing mammal in one of two ways: In the open method, pelts are removed by cutting the skin up the belly from the vent to the chin, then peeling it away from the underlying tissue.

Make sure you are dropping them in an indoor labeled area, like inside of a building with a loading screen, or the very back of a cave (basically places where you cannot. Tip the skin in, and. #pestcontrol #skins #deerhunting #hunting #gathering